Properties Method of use
   1) Concentration of using

Concentration of using Generally, chemicals concentration is 0.2-0.3 % The volume of chemicals supply is variable for viscous condition.  Generally , chemicals supply is 3?5 % volume rate of over sprayed paint. It is necessary to keep pH of circulation water between 7-9. pH is measured by pH meter, pH indicated paper.

   2) Method of supplying
      Continuous supplying is good to keep the anti-viscous effect.
      This chemicals supply in the water continuously by supplying pump.

Packing
      20Kg net : P.P resin container , inside Protection can , disposable container
      200Kg net : P.P resin chemical container

Caution
      Not mix the chemicals and another without designation.f the chemicals

appearance    yellow color liquid      specific gravity    1.0      pH (undiluted solution)    over 11.0

A. Reason to use Reisol 25K and 25A

Contents	Description	Before Improvement	After Improvement	Comments
Facility Operation Management	Preservation Status according to Booth system Contamination	System operation efficiency is decreased and the preservation work is getting too much as the contamination is accumulated.	As the chemical is put into it, there is continuous and voluntary chemical reaction and makes non- sticky sludge.  It removes the contaminating sources such as sticking, coagulum and clogging of arsenic acid paint.	It was a productivity lowering factor because of frequent maintenance work before the improvement.
	Simplify the Preservation Task	Preservation work has been over loaded such as increase of the maintenance cost resulted from frequent removal works more than twice a month and much demand in human resources.	As it does not require the removal works, so there is no additional cost except the chemical cost.  It simplifies the preservation work because it is completed with the sludge separation.	Removal work and removal cost saving effect
	Lengthen the facility life	Life span was reduced because of the facility damage resulted from the sticking and clogging paint removal.	Increase the facility life resulted from the good facility preservation status because of the chemical processing	Increase investment resulted from facility aging.

B.

Contents	Description	Before Improvement	After Improvement	Comments
Contribute to the productivity and cost saving	Shut Down during the removal work	Increase & Decrease of the removal work frequency and elapsed time according to the accumulated amount of the over spray paint	Minimize shut down because it can be managed with the sludge separation only.	- Manufacturing  Plan vs. Actual  Record Analysis  Factors. - Maintain the  most appropriate  conditions of  Line Speed Up.
	Increase & Decrease of productivity according to the status of facility operation conditions	Decrease the efficiency resulted form the bad conditions according to the paint accumulation	Increase the productivity through maintaining the normal conditions
	Work efficiency according to the environment cleanliness	Increase the non-conformity products and decrease the productivity because of the lack of motivation of the workers	Quality improvement resulted from the good working conditions and synergy effect of ???	- Improve    productivity - Fix quality     management     and quality     assurance     system -   Improve      quality of       work       standards
	Bad painting because of over spray mist	Increase dust non-conformity because of paint mist	Remove the dust non-conformity factors by increasing the efficiency in collecting paint mist	Major cause of bad painting

PAINT BOOTH KILLING AGENT REISOL #25K

Paint Booth Killing Agent Reisol #25K is a newly developed paint booth cleaning agent.
It utilizes high molecular substances of a positive ion. It removes the stickiness of
various paints such as melamine, alkyd, acryl, etc. and always maintains the paint booth
clean with its excellent floating effect.

Physical Properties

Shape                                      Milk-colored viscous liquid
Solvency                                  Very good solvency
Main Ingredient                         High molecular cohesive agent
Viscosity                                  300 - 800 cps
PH (1% Solution)                       5.5 - 6.5
Heavy Metal                              None
Foaming                                   None
Gravity                                     1.10 - 1.15
Ignition Point                             None
Freezing Point                           0?
Safety - When used as density indicated it is safe for all metals and plastic materials   
         in a paint booth.

Storing Method - Store at a place of 10 -37?, and in case of being frozen you can     
                  reuse it after melting it. When not using it, keep it covered with the  
                  cap and store in a cool and dry place.

Caution - Be cautious not to touched by eyes and skin, and if it happens, wash with    
           water immediately and consult with a doctor when aftereffect seems to be   
           serious.  

Packing Unit - 20KG PAIL / 200KG DRUM
              
        
PH CONTROL AGENT REISOL #25A

PH Control Agent Reisol #25A is a alkali agent and is to be used after applying a paint
booth cleaning agent to a water booth. It is a supplementary to paint booth cleaning
agent which adjusts the circulation water PH to 8, a light alkali, and helps to obtain
maximum stickiness removal effect.  

Physical Properties

Shape                                   Transparent liquid
PH (1% Solution)                    12 or more
Heavy Metal                            None
Foaming                                 None  
Gravity                                   1.01 - 1.2
Ignition Point                           None
Freezing Point                         0?

Safety - When used as density indicated it is safe for all metals and plastic materials   
         in a paint booth.

Storing Method - Store at a place of 10 -37?, and in case of being frozen you can     
                  reuse it after melting it. When not using it, keep it covered with the  
                  cap and store in a cool and dry place.

Caution - Be cautious not to touched by eyes and skin, and if it happens, wash with    
           water immediately and consult with a doctor when aftereffect seems to be   
           serious.  

Packing Unit - 20KG PAIL / 200KG DRUM

(REISOL NO. # 25K , 25A) Paint Booth Cleaner

1) This chemicals make a over sprayed paint in circulation water into anti-viscous condition.
     Anti-viscous paint float on the water surface. therefore , it is easy to maintenance.
2) This chemicals is available to many kinds of paint. For example, epoxy alkyd acryl melamine urethane and polyester.

3) The Purpose of Removing Paint Viscosity
Over Spray Paint being produced in the circulation water of a Painting Booth has
viscosity, and it clogs up the exhaust system of the Spray Booth and hinders the
harmony of a sudden exhaustion. It causes an inferior painting and not the volatile
solvents inside the booth to be discharged which may lead to security & hygienical
hazards.   

Moreover, most of the overly sprayed paint is deposited on the bottom of the circulation
pit & floating agent, and it solidifies as a rubber form as time progresses which
requires a good deal of manpower and time for its cleaning. Besides, the pathogenic
microorganism produced in the paint may cause offensive odors and environmental risks.

And since the paint dissolves in the circulation water, and its minute particles are
dispersed and increase suspended substances (SS) or soluble solid substances (TDS) in
the water which forces us to exchange the circulation water.

The solvent inside the paint not only increases hydrogen carbonate (HC) but also raise
COD of the circulation water while in exhaustion and promotes corrosion of the facility.

To solve the above-stated problems, the viscosity of the paint needs to be removed, and
cohesive floating is also needed for easy removal of the viscosity removed paint
particles.

(MATERIAL SAFETY DATA SHEET)

NOTE : Read and Understand Material Safety Data Sheet before handling or disposing of product.
Date of issue : March 24, 1995

1.  CHEMICAL PRODUCT AND COMPANY INDENTIFICATION
    Product Name : SEKI Chemicals No. Reisol # 25
    Composition : a mixture / paint killer chemicals
    COMPANY INDENTIFICATION :
                   SEKI Chemicals Co., 704-1, 1-DA, SIWHA INSUSTRIAL COMPLEX,1239-3,
                   JUNGWANG-DONG, SIHEUNG-CITY, KYUNGGI-DO, KOREA
                                                    TEL : 82-31-433-6363
                                                    FAX : 82-31-433-6366
2.  HAZARDS INDENTIFICATION
      Harmful if swallowed
3.  FIRST - AND MEASURES
      Eyes :
         Immediately flush eyes large amounts of running water for at least 15 minutes.
         Hold eyelids apart while flushing to rinse entire surface of eye and lids with water.
         Get medical attention immediately.
      Skin :
         Immediately flush skin with large amounts of running water at least 15 minutes.
         Remove contaminated clothing and shoes. Get medical attention immediately.
      Inhalation :

Remove to fresh air and gargle. If not breathing, give artificial respiration and get  immediate medical attention.

      Ingestion :
         Give plenty of water and induce vomiting . Get immediate medical attention .
4.  FIRE-FIGHTING MEASURES
      Incombustible
5.  ACCIDENTAL RELEASE MEASURES
      Procedures in case of accidental release
         Small scale - Clean up it with a waste towel.

Large scale -

Prevent the out flow to river and on the ocean. And collect it as much as  possible, after that wash away with water.

6.

HANDLING

TORAGE

      HANDLING : Put on a safety clothing.
      STORAGE : Keep it with avoiding direct sunlight.

7.  EXPOSURE CONTROLS
      Concentration of controls : no data
      Allowable concentration : no data
      A measure of equipment : unnecessary

Protector : a safety glass, safety glove,and a safety clothing.

8.

PHYSICAL

CHEMICAL PROPERTIES

     the outside appearance : liquid .
      specific gravity : 1.000(at 25^oC)
      solubility in water : good

9.

STABILITY

REACTIVELY

       flash point : non
      specific oxidation : non
      stability : be stable
      reactively : non
      Other :non
10.  TOXICOLOGICAL INFORMATION
      This mixture does not have toxicological information.
       irritancy : have a little pain to eyes
11.  ECOLOGICAL INFORMATION
      This mixture does not have Ecological information.
12.  DISPOSAL CONSIDERATION
      Ask the company or the party permitted under appropriate Federal, State and local  regulations to dispose.
13.  TRANSPORT INFORMATION
      Pay attention to breaking and accidental release.
14.  REGULATORY
      This product does not come under chemical control laws and regulations in KOREA.
15.  OTHER INFORMATION

The data given here is based on current knowledge and experience. The purpose of this  Safety Data Sheet is to describe the products in terms of their safety requirements. The data does not signify any warranty with regard to the products properties